A soldering iron and suction pump would occupy both hands.
When removing mounted components, if there are only a few parts to be removed, you can work with a soldering iron and solder wick, but if there are many parts to be removed, working with a soldering iron and suction pump is inconvenient because both hands are occupied all the time.
Have you ever had this problem?
Problem Solution
Handa-Shuttaro NEO HSK-300 is the answer!
The function of heating the soldering iron and sucking out the solder are combined into one. Once the solder in the area to be removed is melted, simply press the pump button.
How to use
1. Handa-Shuttaro Connect NEO to an electrical outlet.
Insert the power plug into a 100 VAC outlet and allow the tip tip to warm up well before working.
2. prepare the pump
Push the piston down until it locks.
Let's apply the tip.
Place the tip tip on the solder area to be removed.
Apply the tip lightly and move it in a circular motion to melt the solder evenly.
4. pumping out the solder
Once the solder is melted, press the push button without releasing the tip, and the molten solder will be sucked out.
How to clean up
Frequency of care
Please clean the pump frequently, as solder that has been sucked out will accumulate in the pump.
Cautions for cleaning
To prevent burns, unplug from outlet before cleaning and allow to cool sufficiently.
How to remove the pump
①: Push the piston in until it locks.
②, ③: Pull the suction pump toward you while pushing the pump to release it.
How to clean inside the pump
④: Turn the bottom cover of the pump to the left to remove it.
⑤：Lay a piece of paper on a flat table and tap the pump lightly to remove solder that has accumulated inside.
⑥: Close the lid.
How to install the pump
⑦：Align the rubber packing part of the soldering iron with the lid part of the pump.
⑧: Fit the pump as it slides into place.
⑨: Press lightly on the top of the pump to install.
Tip: How to clean the pipe from the tip to the pump
If solder suction becomes poor, clean as follows.
1): Insert the supplied metal rod from the tip to remove solder stuck in the tube. 2): Insert the supplied metal rod from the tip to remove solder stuck in the tube.
